Options for ABB drives, converters and inverters
Quick installation and start-up guide
FCNA-01 ControlNet adapter module
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
1
3
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using
a Torx TX10 screwdriver.
WARNING! Do not use excessive force,
or leave the screw too loose. Over-
tightening can damage the screw or
module. A loose screw decreases the EMC
performance, and can even cause an operation
failure.
4
Electrical installation
Layout of the module
1
No. Description
1
2
3
4
Lock
Mounting and grounding screw
Bus connector line [A]
7
Network access port (NAP) for a temporary
connection of configuration tools
5
6
7
Bus connector line [B]
6
Diagnostic LEDs
2
Node ID address selection switches
4
5
3
|
Krups Coffeemaker XP4050 User Manual
Kouwell Elec Verbatim KW7003 User Manual
JVC KS FX640R User Manual
Iomega STORCENTER IX12 300R User Manual
Insignia NS CLW01 User Manual
IBM C2B 225 Brick On Sled carrier 128 pin HPC User Manual
HP Hewlett Packard 2354 User Manual
GT Mobile I801 User Manual
Compaq 6B H User Manual
Black & Decker ODC460 User Manual